DOF CRAFT Manuals for Users

20241023-DOF CRAFT5X User Training #2-Web manual Introduction  (https://youtu.be/TZO8s8Ur6HY)
Please check the video introduction about this page. 

 

Updated on 09 October 2024

All informaiton on this web page is for the DOF CRAFT Users.
***Please do not share this web address with anyone***



  

Hyperdent Setting  

Application Part Type Part features Template
Crown/Veneer/Short Crowns Crown (1) Coping margin (blue) Conditionally by material
Crown with implant screw hole Abutment Crown (2) Abutmentbase (pink)
Implant interface (blue cylinder) 		Click here for the video
Abutment (Reverse Milling) Abutment (3) Abutmentbase (pink)
Implant interface (blue cylinder)
Emergence profile (green) 		Click here for the video
Inlay/onlay Inlay/onlay (1) Inlay/onlay (green)    
   
AoX Supra Structure on Ti. Bar Abutment crown bridge Abutmentbase (pink)
Implant interface (blue cylinder) 		Long margin
Powerball/Vortex/Rosen Crown bridge Coping margin (blue)
Manual User define for implant interface
No emergence profile 		Powerball Setting Video
TRI Matrix Connection Abutment Crown (2) External CAM library (blue)
Emergence profile (green) optional 		TRI Matrix

  

User Manuals

 

Calibration 

  • Auto-Calibration 
    1) Collet cleaning - tightening (Click here for the video.) 
    2) Remove any jig 
    3) Clean the front, back, outer and inner of the holder for ZERO dust condition
    4) Cover irrigation tips with a blue plastic magnet cover
    5) Switch to the DRY mode (Block the drain with a paper if necessary) 
    6) Auto-Calibration (Click here for the video.)
    7) Check 'Calibration Difference' parameters: They have to be within 0.009 
  • Manual Calibration 
    1) Go go 'Manual Calibration 
    2) Use a digital vernier caliper to measure (measure over 3 times and read the repeating number.) 
    3) Type in the the screen, and send the photos to us   

 

DOF Support Videos on Youtube (Clikc here to see)

  1. When NC files cannot be transferred due to network problems
  2. Tool
  3. Switch between Wet-Dry
  4. How to use the torque driver?
  5. Jig fastening method
  6. Fixing premill abutments onto the jig holder
  7. Non-hex jig fastening method
  8. Spindle Error
  9. Probe Sensor, Check Alarm
  10. Tool Alarm
  11. When the milling result is not good as usual
  12. Calibration Error
  13. F Beep from the Dust Collector
  14. When coolant does not come out
  15. How to Clean the Chamber Room and Replace the Water Tank
  16. Emptying Wet Filter
  17. Checking Coolant Concentration
  18. Checking the tool life and replacing tools
  19. Shutting Down CRAFT 5X
  20. Cleaning the spindle collet
  21. Dust collector Filter replacement and Coolant Management  

  

Sample STL files 

Click here to see 

  

STL Viewer Software

Click here to download



 

Post Process 

 

Support Contact 

Please provide information as below. 

  • Part Type
  • Part Feature Setting
  • Template
  • Screenshot of Hyperdent Setting
  • Failure Image
  • Please contact us through the provided communicational channel, support@cm-medical.com.au 

  

Thank you always!
CM MEDICAL 
info@cm-medical.com.au 
1300 466 588  

Back to top